Articles | Volume 16, issue 2
https://doi.org/10.5194/ms-16-627-2025
© Author(s) 2025. This work is distributed under the Creative Commons Attribution 4.0 License.
Research article
| 
27 Oct 2025
Research article |
| 27 Oct 2025
| 27 Oct 2025
Research on surface integrity of AISI M2 workpiece hard-turning precision machining with cubic boron nitride cutting tool
Cited articles
Altan Özbek, N.: Effects of Shallow and Deep Cryogenic Treatment on Tool Flank Wear and Surface Roughness in Machining 41Cr4 Steel, J. of Materi. Eng. and Perform., 32, 9638–9648, https://doi.org/10.1007/s11665-023-07866-w, 2023.
Bartarya, G. and Choudhury, S. K.: Effect of cutting parameters on cutting force and surface roughness during finish hard turning AISI52100 grade steel, Procedia CIRP, 1, 651–656, https://doi.org/10.1016/j.procir.2012.05.016, 2012.
Bertolini, R., Bedekar, V., Ghiotti, A., and Bruschi, S.: Surface integrity and corrosion performances of hardened bearing steel after hard turning, Int. J. Adv. Manuf. Technol., 108, 1983–1995, https://doi.org/10.1007/s00170-020-05352-4, 2020.
Branco, F. K., Delijaicov, S., Bordinassi, É. C., and Bortolussi, R.: Surface integrity analisys in the hard turning of cemented steel AISI 4317, Mat. Res., 21, e20171032, https://doi.org/10.1590/1980-5373-MR-2017-1032, 2018.
Bulaha, N.: Analysis of service properties of cylindrically ground surfaces, using standard ISO 25178-2: 2012 surface texture parameters, in: Environment. Technologies. Resources, Proceedings of the 10th International Scientific and Practical Conference, 1, 16–21, https://doi.org/10.17770/etr2015vol1.228, 2015
